Wholesale Confined Cu-Al Cable Lug Manufacturer – DT、DTL two palm holes copper aluminium cable lugs/bimetallic lugs – Pengyou Power

1. The product implements the technical conditions of GB/T14315-2008 “Crimp-type copper and aluminum terminals and connecting pipes for power cable conductors”;
2. The internal and external surfaces of the product should be smooth and smooth, and no burrs, cracks, folding, and crushing marks are allowed: the terminal board is required to be flat:
3. Put the factory standard, specification and model on the label;
4. The thickness deviation of the wiring hole is not more than 10% of the thickness;
5. Unmarked tolerances are in accordance with GB/T 1804-m.

Pure Copper Double Holes Cable Connector

Description:
The cable connector is used for connection and continuation in the end of cable to make the cable and electric appliance more tight and safe connected,which is the common material used in construction,electric equipment and electric appliance connection.It is known as copper wire ear in some area.In accordance with the requirements and regulations for wire connection in our country,the corresponding wire connection terminal connector must be used in the cable end when connecting wires and terminal connector.For the copper wire with multi-strand over 4mm²,the cable lug should be installed first and then connect with the terminal connector.

Advantage:
The product is with good appearance and specification,electrical conductivity and safe.

Specification:
Material:Red copper,yellow brass;surface treatment:national specification of sliver plated welding joints

Application:
The terminal connector is mainly used in household electrical appliance,mechanical engineering factory,shipyard and power distribution box,etc..

Product Description

DTL Series Cu and Al cable terminals with two holes are suitable for transition connection of the circular aluminum wires,hemicycles-sector aluminum wires, power supply cables in the distribution equipment and copper terminals of the electrical equipment. They are made from Cu 99.9% purity and Al 99.5 purity. The barrel is friction wedded to the palm, so that the best possible transition between copper palm and aluminum barrel. To avoid oxidization of the aluminum barrel capped greased. When crimping, it forced the joint compound into conductor strands.

Copper and aluminum wiring terminals and lugs features

1.product features
Copper-aluminum friction welding process, copper-aluminum transition is located at the round bar, with large cross section, high weld strength and resistance to electrochemical corrosion;
The electrical contact surface is flat, the conductive performance is superior, and the advantages are low resistance and small temperature rise;

2.structural characteristics
Executive standard
Meet the technical requirements of GB/T 2314.

Raw material
Made of pure copper and aluminum bars, the material is dense;

Connection method
The product is connected to the cable using a crimping process for reliable connection.

use range and field
It is suitable for connecting 35kV (Um=40.5kV) and below power cable conductors to the end of the electric device. Other wires and cables for fixed laying can also be used.

Bimetal palm compression cable lugs DTL-1